Hilti PMP 34 Mode D'emploi page 114

-CAUTION-
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
part 15 of the FCC rules. These limits are designed to
provide reasonable protection against harmful inter-
ference in a residential installation. This equipment gen-
erates, uses and may radiate radio frequency energy.
Accordingly, if not installed and used in accordance
with the instructions, it may cause harmful interfer-
ence to radio communications.
However, there is no guarantee that interference will
not occur in a particular installation.
If this equipment does cause harmful interference to
radio or television reception, which can be determined
by turning the equipment off and on, the user is encour-
aged to try to correct the interference by taking the fol-
lowing measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and
receiver.
Printed: 07.07.2013 | Doc-Nr: PUB / 5070096 / 000 / 00
– Connect the equipment to an outlet on a circuit dif-
ferent from that to which the receiver is connected.
– Consult your dealer or an experienced TV/radio tech-
nician for assistance.
Changes or modifications not expressly approved by
Hilti could limit the user's right to operate the equip-
ment.
Labels
Hilti =trademark of Hilti Corp., Schaan, LI Made in Germany
6V=
100mA max.
Item.no.
S.No.
Manufact:
ko
PMP 34
109