Manufacturer's Warranty - Tools; Fcc Statement - Hilti PMP 34 Mode D'emploi

12. Manufacturer's warranty – tools
Hilti warrants that the tool supplied is free of defects
in material and workmanship. This warranty is valid
so long as the tool is operated and handled correctly,
cleaned and serviced properly and in accordance with
the Hilti Operating Instructions, and the technical sys-
tem is maintained. This means that only original Hilti
consumables, components and spare parts may be
used in the tool.
This warranty provides the free-of-charge repair or
replacement of defective parts only over the entire lifes-
pan of the tool. Parts requiring repair or replacement
as a result of normal wear and tear are not covered by
this warranty.
13. FCC statement (applicable in USA)
-CAUTION-
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
part 15 of the FCC rules. These limits are designed to
provide reasonable protection against harmful inter-
ference in a residential installation. This equipment gen-
erates, uses and may radiate radio frequency energy.
Accordingly, if not installed and used in accordance
with the instructions, it may cause harmful interfer-
ence to radio communications.
However, there is no guarantee that interference will
not occur in a particular installation.
If this equipment does cause harmful interference to
radio or television reception, which can be determined
by turning the equipment off and on, the user is encour-
aged to try to correct the interference by taking the fol-
lowing measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and
receiver.
Printed: 07.07.2013 | Doc-Nr: PUB / 5070096 / 000 / 00
Additional claims are excluded, unless stringent
national rules prohibit such exclusion. In particular,
Hilti is not obligated for direct, indirect, incidental
or consequential damages, losses or expenses in
connection with, or by reason of, the use of, or inabil-
ity to use the tool for any purpose. Implied warranties
of merchantability or fitness for a particular purpose
are specifically excluded.
For repair or replacement, send tool or related parts
immediately upon discovery of the defect to the address
of the local Hilti marketing organization provided.
This constitutes Hilti's entire obligation with regard to
warranty and supersedes all prior or contemporane-
ous comments and oral or written agreements con-
cerning warranties.
– Connect the equipment to an outlet on a circuit dif-
ferent from that to which the receiver is connected.
– Consult your dealer or an experienced TV/radio tech-
nician for assistance.
Changes or modifications not expressly approved by
Hilti could limit the user's right to operate the equip-
ment.
Labels
Hilti =trademark of Hilti Corp., Schaan, LI Made in Germany
6V=
100mA max.
Item.no.
S.No.
Manufact:
en
PMP 34
19