General Maintenance; Carbon Brushes - Skil PL201201 Guide D'utilisation

To install planer blades:
a. Disconnect the plug from power source.
b. Place the planer upside down on a flat surface.
c. Clean all surfaces before installing the new blade or reversing the old blade, as this will
ensure an accurate blade setting and proper tool performance.
d. Slide the blade into the blade holder of the clamping element. The blade groove must
engage with the blade holder.
e. Tighten the three clamping screws again with the wrench (provided).
Fig. 12
Clamping Screws (x3)
NOTICE: Your planing surface will end up rough and uneven unless the blades are set
properly and securely. The blades must be mounted so that the cutting edge is absolutely
level relative to the surface of the front and rear base.
Service
CAUTION
cause serious hazard .
Service Center or Authorized SKIL Service Station.

General Maintenance

CAUTION
Periodically inspect the entire product for damaged, missing, or loose parts such as screws,
nuts, bolts, caps, etc. Tighten securely all fasteners and caps and do not operate this product
until all missing or damaged parts are replaced. Please contact customer service or an
authorized service center for assistance.

Carbon Brushes

The brushes and commutator in your tool have been engineered for many hours of
dependable service. To maintain peak efficiency of the motor, we recommend that the brushes
be examined every two to six months. Only genuine SKIL replacement brushes specially
designed for your tool should be used.
16
Preventive maintenance performed by unauthorized personnel may
result in misplacing of internal wires and components which could
We recommend that all tool service be performed by a SKIL Factory
When servicing, use only identical replacement parts . Use of any
other parts could create a hazard or cause product damage .
Blade Blade Holder