Cook & Hold - Jenn-Air JJW7530DDS Guide D'utilisation Et D'entretien

O C
VEN OOKING
Baking
To set Bake:
1. Press the Bake pad.
• BAKE and 000 will flash in the display.
2. Select the oven temperature. Press the
Autoset pad for 350° F or the appropriate number pads.
• Each additional press of the Autoset pad will increase
the temperature by 25°.
• The oven temperature can be set from 170° to 550°.
3. Press Bake pad again or wait four seconds.
• BAKE will stop flashing and light in the display.
• 100° or the actual oven temperature if over 100° F will
display. It will rise in 5° increments until the preset
temperature is reached.
4. Preheating will take approximately four minutes. Wait until
oven is preheated to add food.
• When the set oven temperature is reached, one long
beep will sound.
• The set temperature will display.
• To recall set temperature during preheat, press Bake pad.
5. Place food in the oven.
6. Check cooking progress at the minimum cooking time.
Cook longer if needed.
7. When cooking is finished, press
CANCEL pad.
8. Remove food from the oven.
Baking Notes:
• To change the oven temperature during cooking, press
Bake, then press the Autoset or appropriate number pads
until the desired temperature is displayed.
• To change the oven temperature during preheat, press the
Bake pad twice, then press the Autoset pad or appropriate
number pads until the desired temperature is displayed.
• If you forget to turn off the oven, it will automatically turn
off at the end of 12 hours. If you wish to deactivate this
feature, see page 10.
Baking Differences Between Your Old
and New Oven
It is normal to notice some baking time differences between a
new oven and an old one. See "Adjusting the Oven Temperature"
on page 11.
Cook & Hold
When using the Cook & Hold option, the oven begins to heat
immediately after the control has been set. Then, the oven
cooks for a specified length of time. When that time has
elapsed, the oven will keep the food warm for up to an hour
then automatically turn off.
To set Cook & Hold:
1. Press the Cook & Hold pad.
• HOLD will flash to indicate that you are in
Cook & Hold programming.
• 00:00 will flash in the display.
2. Select the amount of time you want to cook by using the
number pads.
• HOLD continues to flash.
• The time will light in the display.
• Time can be set from ten minutes (00:10) to
eleven hours, 59 minutes (11:59).
3. Press Bake pad and select the oven tempera-
ture. Press the Autoset pad for 350° F or the
appropriate number pads.
• BAKE will flash.
• The oven temperature can be set from
6
cont.