Fault Codes - Jenn-Air JJW7530DDS Guide D'utilisation Et D'entretien

O C
VEN OOKING
To set the Clock:
1. Press the Clock pad.
• The time of day flashes in the display.
2. Press the appropriate number pads to set the time of day.
• Colon flashes in the display.
3. Press the Clock pad again or wait four seconds.
• The colon will remain on.
When electrical power is supplied or after a power interrup-
tion, the last clock time before power was interrupted will
flash.
To recall the time of day when another time function is
showing, press the Clock pad.
Clock time cannot be changed when the oven has been
programmed for Delay cook or clean or Cook & Hold.
To cancel the Clock display:
If you do not want the time of day to display:
Press and hold the CANCEL and Clock pads
for three seconds. The time of day will
disappear from the display.
When the clock display is canceled, press
the Clock pad to briefly display the time of
day.
When the clock display is canceled, after 15 minutes, the oven
control will go into Standby Mode to save energy. The display
will be blank and the oven light will not operate. To "wake up"
the control from Standby Mode, press any touchpad. A double
beep will sound.
To restore the Clock display:
Press and hold the CANCEL and Clock pads for three sec-
onds. The time of day will reappear in the display.
Timer
The timer can be set from one minute (00:01) up to 99 hours
and 59 minutes (99:59).
The timer can be used independently of any other oven
activity. It can also be set while another oven function is
operating.
The Timer does not control the oven. It only controls a
beeper.
To set the Timer:
1. Press the Timer pad.
• 00:00 and TIMER flash in the display.
2. Press the appropriate number pads until the correct time
appears in the display.
• The colon and TIMER will continue to flash.
3. Press Timer pad again or wait four seconds.
• The colon stops flashing and the time begins counting
down.
• The last minute of the timer countdown will be displayed
in seconds.
4. At the end of the set time, one long beep will sound and
"End" will be displayed.
5. Press the Timer pad to clear the display.
To cancel the Timer:
1. Press and hold the Timer pad for three
seconds.
OR
2. Press the Timer pad and press '0' using the
number pads.
Locking the Control
and Oven Door
The touchpad and oven door can be locked for safety,
cleaning, or to prevent unwanted use. The touchpads will not
function when locked.
If the oven is currently in use, the touchpads and door cannot
be locked.
The current time of day will remain in the display when the
touchpads and door are locked.
To lock:
1. Press and hold the CANCEL and Cook &
Hold pads for three seconds.
• OFF appears in the display
• LOCK flashes while the door is locking.
To unlock:
Press and hold the CANCEL and Cook & Hold pads for three
seconds. OFF disappears from the display.
Note: The touchpads and oven door cannot be locked if
the oven temperature is 400° F or above.

Fault Codes

BAKE or LOCK may flash rapidly in the display to alert you if
there is an error or a problem. If BAKE or LOCK flash in the
display, press CANCEL pad. If BAKE or LOCK continue to
flash, disconnect power to the appliance. Wait a few minutes,
and then reconnect power. If the flashing still continues,
disconnect power to the appliance and call an authorized
servicer.
5