Feed; Base Plate; Transport; Position - Horizontal / Oblique - GÖLZ KB 125 Mode D'emploi

Foreuse carotteuse
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

KB 125
Bedienungsanleitung / Operating instructions / Mode d'emploi

3.2.2 Feed

The feed (1) provides for a stable guide of the arbor during the
drilling. The adjusting screws (3) made of aluminium serve for
slight adjustment of the guide plugs. By means of the level (4)
it is possible to adjust the support. The cross handle (5) can
easily be switched from the left to the right side. The wing
screw (6) serves for braking and fixing the feed. (Bild 3-2)

3.2.3 Base plate

The base plate (1) provides the drill column with the required
stability and makes it, in addition, possible to fix the column
horizontally. There are two possibilities to mount the base onto
the soil and the wall:
• Wedge anchor and quick clamping rod
• Vacuum hold down and vacuum pump (without fig.)
and quick clamping column (without fig.).
The adjusting screws (2) in the base serve to put the core drill
rig in a horizontal position. For mounting it on the soil there is
a level integrated in the unit, for mounting it on the wall a
water-level.
For additional support the core drilling machine is clamped
between the base plate and the ceiling or wall by means of a
quick clamping column. (Bild 3-3)
Bild 3-3

3.2.4 Transport

The core drill rig (without motor) can easily be transported by
means of the handle (2).The motor with quick clamping plate
can easily be mounted and dismounted. (This is a very helpful
when mounting it onto the wall). (Bild 3-4)
3.2.5 Position – horizontal / oblique
The arbor is continuously adjustable up to an angle of 45
degrees. Loosen the screw (1), move the column (3) to put it
into the desired position and fix the screws again.
Note: Before adjusting the arbor (3) the socket head screw
under the arbor (behind the centring device for the drill bit) has
to be removed.

3.2.6 Drill rig motor and motor plate

The motor is mounted to the carriage by means of a motor plate
or a motor neck holding fixture 60 mm, depending on the type of
Bild 3-4
motor.
- 19-
02951250999
5004593-02

Publicité

Table des Matières
loading

Table des Matières