Ryobi RYi1802B6 Manuel D'utilisation page 16

GENCONTROL LCD DISPLAY
™
See Figure 6.
NOTE: The LCD display will not work unless the product is
powered on.
Battery charge level:
The battery charge level indicator shows how much charge
is remaining in the battery.
Load level:
The load level indicator shows the connected load. If the
product is approaching the maximum wattage/amperage
capacity, the indicator will blink. If the load level capacity is
exceeded, the LCD display will show OVERLOADED. Re-
move all loads from the product and press the AC output
button to reset (see fig. 5). Add loads back to the product
one at a time, being careful not to exceed the product's
wattage rating.
Run time:
The LCD display shows the run time based on when the unit
was switched on.
Bluetooth :
®
Once paired, the LCD display indicates whether or not the
app is connected through Bluetooth
GENCONTROL
™
Input charging power:
The LCD display will show charging condition and full charge
output.
USB CHARGING PORTS
See Figure 7.
NOTE: The main power button must be on for the USB ports
to be active.
The USB-dedicated charging ports will charge most USB-
compatible devices when used with the appropriate USB-A
or USB-C cable (not provided).
 For charging USB-C specific devices or other devices up
to 3 amps, connect to the USB-C ports.
OPERATION
 For MP3, cell phones, tablets, and other devices up to
2.1 amps, connect to the USB-A ports.
NOTE: The USB-dedicated charging port provides power
only; it does not provide any communication capabilities.
Suitable USB cables must be provided by the user.
USING THE LED TASK LIGHT
See Figure 8.
 Press the task light control button once to turn the LED
task light on. The light will illuminate on the high setting.
 Continue to press the button to cycle through other
available settings — low, red, blinking red, and off.
PAIRING THE BLUETOOTH
See Figure 9.
Installing the RYOBI
tooth
enabled iOS or Android device allows you to view and
®
control many of the product's functions from your device.
 From the app store on your iOS or Android Bluetooth
enabled device, locate and install the RYOBI
GENCONTROL
 Open the app and follow the directions as shown in the
GENCONTROL
.
®
NOTE: Make sure Bluetooth
 Press the main power button on the power station to turn
the LCD display on.
 Push and hold the "Hold to Pair" button to the right of the
LCD panel on the product until the LCD panel displays
"Pairing Mode."
 The LCD screen on the product and the app on your
device will indicate a successful pairing.
NOTE: If the product and app do not pair, make sure that
"Pairing Mode" is displayed during the pairing process
and that Bluetooth
 Press the menu icon in the top left corner of the app
screen. This will show you the available features that can
be controlled through the app.
12 — English
PRODUCT
®
GENCONTROL app on your Blue-
™ ™
app.
™
app.
™
is enabled on your device.
®
is enabled on your device.
®
®
™