Add Contact List Entries - Toyota PZ420-I0291-ME Mode D'emploi

6.3. Add contact list entries

You can store a list of names and phone numbers locally in the hands-free system's
contact list. The contact names stored in the Contact List can be called using the
Call <name> command.
The Contact List can support up to 50 entries. The Contact List is only available when
a handset device is connected to the hands-free system.
You can enter up to 50 digits for each Contact List entry. You can also use +, *, or #
characters when dialing a number. Wait and Pause commands are also accepted.
ò
Caution: For safety reasons, it is recommended that contact list entries be added
while the vehicle is stationary.
ó
Note: Speak numbers as continuous digits. For example, dictate 555-2211 as
5-5-5-2-2-1-1 (not 5-5-5-twenty-two-eleven).
Add a contact
1 Press the Multi-function button.
The system responds: Phone menu. {Say a command}.
2 Say Contact List.
The system responds: Contact list. {Say a command}.
3 Say Add Contact.
The system responds: Say the name.
4 Say the name of the contact to be stored.
— if an error is detected, the hands-free system asks you to try again
— if the name is accepted, the system responds: Say the number for <name>.
5 Say the number of the contact to be stored as either:
— an entire number (without pauses between digits), or
— as a series of segments (for example, say the first three digits, wait for the hands-
free system to recite the digits heard, then say the next three, etc.), until you have
dictated the entire number.
The hands-free system repeats the number it hears.
6 When you have correctly entered the entire phone number, say Store (or Yes) to store
the contact.
The system responds: Contact added. Would you like to add another contact?
7 To add another contact, say Yes. Otherwise say No to exit contact list.
A
Bluetooth® hands-free system 15