Cleaning; Battery; Maintenance; Replace The Blades - Husqvarna AUTOMOWER 105 Manuel D'utilisation

5.1 Cleaning

It is important to keep the robotic lawnmower clean. A
robotic lawnmower with a lot of grass stuck to it will find
it harder to travel up slopes, will perform worse and is
exposed to greater wear and tear. For better operating
reliability and longer service life: check and clean the
robotic lawnmower regularly and replace worn parts if
necessary. It is recommended to clean using a soft
brush.
To reduce the risk of damage to electrical components
in the robotic lawnmower and its charging station, we
recommend that all connections to the charging station
are disconnected (power supply, boundary wire and
guide wires) if there is a risk of a thunderstorm.
WARNING: When the robotic lawnmower is
turned upside down the main switch must
0 position.
always be in the
The main switch should be set in the
during all work on the mower's chassis, such as
cleaning or replacing the blades.
CAUTION: Never use a high-pressure washer
or even running water to clean the robotic
lawnmower. Never use solvents for cleaning.

5.2 Battery

The battery is maintenance-free, but has a limited life
span of 2 to 4 years.
WARNING: Only charge the robotic lawnmower
using a charging station which is intended for it.
Incorrect use may result in electric shock,
overheating or leakage of corrosive liquid from
the battery. In the event of leakage of electrolyte
flush with water and seek medical help if it
comes in contact with the eyes etc.
WARNING: Use only original batteries
recommended by the manufacturer. Product
safety cannot be guaranteed with other
batteries. Do not use non-rechargeable
batteries.
CAUTION: The battery must be charged fully
before winter storage. If the battery is not fully
charged it can be damaged and in certain cases
be rendered useless.
Below indicates that the battery is getting old and
eventually needs replacing:
• The operating time for the robotic lawnmower is
shorter than normal between charges. This leads to
more charging cycles than normal, which increases
the risk of tracks forming near the charging station.

16 - Maintenance

5 Maintenance
• The robotic lawnmower is found standing out on the
lawn with
that the robotic lawnmower does not have battery
capacity enough to find the charging station.
The battery is fine as long as the robotic lawnmower
maintains a well-cut lawn.
Note: Battery life is dependent on the length of the
season and how many hours a day the robotic
lawnmower is operating. A long season or many hours
of use a day means that the battery must be replaced
more regularly.
Contact your local Husqvarna representative to replace
the battery.

5.3 Replace the blades

WARNING: Always use blades and screws of
0 position
the right type. Husqvarna can only guarantee
safety when using original blades. Only
replacing the blades and reusing the screw can
result in a screw wearing during mowing and
shearing. The blades can then be propelled
from under the body and cause serious injury.
Replace worn or damaged parts for safety reasons.
Even if the blades are intact, they should be replaced on
a regular basis for the best mowing result and low
energy usage.
All 3 blades and screws must be replaced at the same
time to obtain a balanced cutting system.
Use Husqvarna original blades embossed with the
crowned H-mark logotype, see
page 23 .

5.3.1 To replace the blades

1. Set the Main switch to position
2. Turn the robotic lawnmower upside down. Place the
robotic lawnmower on a soft and clean surface to
avoid scratching the body and the hatch.
3. Rotate the skid plate so that its holes align with the
screws for the blade.
4. Remove the 3 screws. Use a straight slot or cross-
tip screwdriver.
5. Remove each blade and screw.
6. Fasten new blades and screws.
7. Check that the blades can pivot freely.
Empty battery message. This indicates
Guarantee terms on
0 .
772 - 001 - 29.05.2018