Brewing Coffee With The Timer Function - Unold 28465 Notice D'utilisation

11. You can interrupt the brewing cycle any time by pressing the button "EIN/
AUS" two times consecutively. The indicator lamp in the button lights up
blue for about 10 seconds. As soon as you press the "EIN/AUS" button
again, the brewing cycle resumes.
12. You can also remove the pot to pour coffee any time during the brewing
cycle. However, the pot must be put back on the plate within 30 seconds,
since otherwise the filter could overflow.
13. Remove the permanent filter and dispose of the coffee grounds.
The appliance becomes very hot during operation
and maintains the heat during some time after
disconnection.

BREWING COFFEE WITH THE TIMER FUNCTION

1. First, make sure that the appliance has been set to the correct time; other-
wise, the timer cannot function correctly (chapter "Setting the time").
2. Prepare the appliance as described in the section "Brewing Coffee without
the timer function", step 1 - 7.
3. Press the "PROG" button – the current time is displayed.
4. Press the "PROG" button again. The display shows "Timer" at the upper
left.
Timer
15:00
5. Now press the "STD" and "MIN" buttons until the desired start time for the
brewing cycle is set. After about 10 seconds with no input, the appliance
returns to the initial setting.
6. Then press the "PROG" button until the words "Clock" and "Timer" no
longer appear on the display. The indicator lamp in the "PROG" button
lights up for about 10 seconds and then goes out again.
7. Press the "EIN/AUS" button two times consecutively. The indicator lamp in
the button lights up blue and blinks.
8. If you wish to check the set time, press the "PROG" button again. The dis-
play shows "TIMER" and the set time at the upper left. You can now change
the time if you wish.
9. When the set time is reached, the brewing cycle begins.
28
Copyright UNOLD AG | www.unold.de