Publicité
Les langues disponibles
Les langues disponibles
5.2. Cable entries
•
Take the cable routing into consideration when planning the installation. The supply cable can be routed
into the enclosure from the rear or bottom. Default cable routing is from the bottom.
•
The M32 cable gland for the supply cable is pre-assembled on the bottom of the charging station.
•
If it is necessary to open additional cable entries, you have to disassemble the charging station.
Installation steps when cable routing is from alternative cable entries
1.
Disassemble the charging station.
Remove the screws 5pcs.
4
Remove the installation box from the base.
Base
TX20
Installation box
Screw fixing: Remove the screws 2pcs.
1
Mechanical lock: Unlock the hatch with a coin or suchlike.
LERAK131B_20221004
EV Charging Station
Remove the screws
3
2pcs.
Remove the screws 4pcs.
2
Remove the installation box cover.
Installation
box cover
29 / 68
Publicité
