Troubleshooting; Care And Maintenance - Electrohome SelfSet EAAC600 Guide De L'utilisateur

If you experience a problem with this unit, check the chart below before calling for service.
SYMPTOM
GENERAL
Power does not come on.
RADIO
No Sound.
Noise or sound distorted
on AM or FM.
Radio does not turn off
with SLEEP feature.
CLOCK
Incorrect Time.
Alarm does not turn on.
Precautions
1. Always turn off the unit after use.
2. Keep the unit away from magnetic objects, water or heat sources.
3. Use a clean soft cloth moistened with lukewarm water to clean the cabinet. Never
use chemical cleaners that could damage the finish of the unit.
4. Disconnect the unit from any power sources before cleaning.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates,uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:

TROUBLESHOOTING

POSSBILE CAUSE
AC cord not plugged in.
Power is not on.
VOLUME control at minimum
position.
AM-interference from traffic.
FM-antenna wire not extended.
Power is not turned off.
Batteries inserted incorrectly,
no connected or dead.
Clock not set.
Alarm is not set to turn on.
Clock is not set.
Alarm time is not set.

CARE AND MAINTENANCE

POSSIBLE SOLUTION
Insert plug firmly into AC outlet.
Press POWER to turn the unit on.
Turn the VOLUME control up.
Tune the radio for better AM
reception.
Extend antenna wire.
Press POWER to turn the unit off
before activation sleep.
Check batteries.
Set the clock.
Press ALARM ON/OFF to turn the
alarm on.
Set the clock.
Set alarm time.
- 11 -