Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Rear Panel
8
7
1.
Inputs (10 Universal Analog): Connect balanced or unbalanced audio sources to these mono
inputs. The inputs can function in 4 modes of operation: Condenser Mic with 48V phantom
power, Dynamic Mic, Balanced +20 dBU Line, and Unbalanced Line+.
Tip: Unbalanced Line+ sums two unbalanced signals (such as left and right RCA lines) when
one is connected to the positive (+) input and one is connected to the negative (-) input.
2.
Outputs: (10 Balanced Line): Connect line-level devices to these balanced +20 dBU mono
outputs with EMI filtering and transient on/off muting.
3.
Universal High-Power RAD Ports: These 6 ports support any RAD or DR device (no power
supply required). Each port provides up to 15 watts of peak power, and supports up to 2 audio
in and 2 audio out channels plus control.
4.
Computer Ethernet Port (Ethernet): Connect this port to a router or similar access point during
setup. After Terminal 1010x is properly configured, you can connect a computer to another port
on the same router or access point, allowing you to use a web browser to access an interface
to control Terminal 1010x.
5.
Expansion Bus: This port provides support for legacy expansion devices and future hardware
releases.
6.
Universal Logic Ports (Euroblock): Each of these 2 ports allow a system designer to read a
contact closure, drive an indicator or relay, or read a potentiometer.
7.
Optional Card Slot: Insert an optional DanteX card or other compatible expansion card into
this slot.
8.
Power Input (IEC): Use a standard IEC cable to connect this input to a power outlet.
6
3
5
4
1
2
7
Publicité
Table des Matières
