Rane TERMINAl 1010x Guide D'utilisation Rapide page 9

Controlling Terminal 1010x Remotely
You can use a web-based interface on your computer to control Terminal 1010x remotely.
To set up Terminal 1010x for use with its web interface:
1. Use standard Ethernet cables to connect Terminal 1010x's Computer Ethernet port to a
DHCP (Dynamic Host Configuration Protocol)-enabled router or similar access point, and
then connect your computer to another port on the same router or access point.
2. Once connected to a network, Terminal 1010x will automatically acquire a dynamic IP
address that you can use. This may take a few seconds.
3. Press the Home button on Terminal 1010x until the Wired Network Settings appear on
the display, and then make note of the DHCP IP address (e.g., 10.10.10.182).
To open the Terminal 1010x web interface:
1. Open a web browser on your computer.
2. In the browser, enter the DHCP IP address shown in Terminal 1010x's Wired Network
Settings (e.g., http://10.10.10.182) to load the web interface.
3. Press the Login button, and then enter the password for Full access mode. The default
password is admin.
9