Rear Panel - Rane RAD26 Guide D'utilisation

Rear Panel

1. RAD Port (RJ-45): This port uses a Shielded CAT 5e
cable to connect to any HAL RAD Port. The CAT 5
distance from a HAL RAD Port to the RAD26 must not
be more than 100 m (325 ft). RPI (sold separately) can
go anywhere in between to supply display and amplifier
power. RPI is required when using HAL models.
2. Inputs: Two balanced, switchable Mic / Line / Line-Plus
audio inputs are available. The Line-Plus inputs accept
unbalanced left and right signals and sums them to
mono. 24 V phantom power is available for condenser
mics. Three Logic inputs allow for additional controls
such as push to talk, push to mute, etc.
3. Amplifier Outputs: Two 8Ω loudspeaker outputs can power stereo 4-watt speakers, or a single 8-
watt speaker.
4. Outputs: Two balanced line outputs are available for driving an external amplifier or powered
subwoofer for more output. Three Logic outputs allow for control of another device, light, projector,
hot tub, etc.
RAD26 Rear Wall Mount Bracket RPI (Remote Power Injector)
(included)
The midspan power injector (not PoE) connects
shielded CAT 5e (or better) cables between any
HAL and the RAD26 to deliver communications
and the extra power needed for the display and
amplifiers. The RPI is inserted anywhere between
the HAL and the RAD26, which can be up to 100
meters (325 feet) apart.
1
2
4
3
(sold separately)
7