Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
6. Bending by eye measurement.
Since the unit uses a variable-speed switch, you can bend the rebar to your desired angle
by eye measurement in addition to the dial setting.
(1) Set the setting dial to a larger angle than you desire.
(2) Pull the switch trigger lightly and bend the rebar slowly.
(3) When the rebar is bent to the desired angle, stop pulling the switch. If the bar is still
small of the desired angle, pull the switch again.
(4) Remove the rebar after bending has been finished. Then, pull the switch once more
and return the bending roller to the home position. (Continue pulling the switch until
the bending roller begins reverse rotation.)
7. Removing rebar during bending operation
When bending out at a low speed in "bending by
eye measurement", the rebar can sometimes get
caught in the bending roller due to its own flexure.
If this occurs, you can return the bending roller to
the home position by pulling the switch again after
setting the setting dial to the "return" position.
This is the same method used to remove the rebar
when it gets caught during cutting operation. (Fig.
20)
8. Using hole to fix unit in place.
A hole is provided at the center of the unit to fix and
stabilize it. This hole comes in quite handy when
used in the following manner. (Fig. 21)
For bending operation when the unit is fixed to
a work bench.
This hole will prove very convenient when the
unit is bolted to a suitable work bench.
(Bolt size M10, less than W3/8.)
English
Fig. 20
Tail cover
Bolt
Set screws
Hole to fix
Nut
unit
Fig. 21
19
Publicité
Table des Matières
