Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
English
CAUTION:
Install the cutter and accessories securely according to the instruction manual. If you fail
to install them properly, they may come off and cause an injury.
Be sure to unplug the power cord from the receptacle when the cutter is checked,
cleaned, and replaced. Failure to do so can result in a serious injury.
HOW TO USE (BENDING)
1. Setting bending angles by setting dial.
The bar can be bent according to the angles indicated on the setting dial, as shown in Fig.
11.
Dial indication
Condition of rebar
When bending the #3 (3/8") and #4 (1/2") rebars at
the same dial position, the bending angles differ
slightly due to the difference in bar diameter.
Therefore, even when using the same angle setting,
we recommend that you change the position of the
dial slightly for the different bar diameters, as
illustrated in Fig. 12.
You will be able to bend the rebar at an angle that
is close to the dial indication of you set the #3 (3/8")
rebar nearer to the left of the angle mark and the #4
(1/2") rebar nearer to the right of the angle mark.
NOTE
Even at the same dial setting position, the bending
angle can sometimes differ if the diameter or hardness
of the rebar is different. Use the angle marks merely as
a rough guideline.
2. Ordinary bending.
(1) Set the unit in the position with the turntable up
as shown in Fig. 13.
(2) Make sure that the cover is closed.
(3) Set the setting dial at the desired angle. (Fig. 12)
(4) Place the rebar on the stopper of the center
plate and set it correctly as shown in Fig. 13.
(5) Pull the switch trigger and bent the rebar.
16
45°
45°
90°
90°
135°
Fig. 11
Bending length
5" (120 mm)
←→
135°
180°
180°
Adjusting position
Fig. 12
Center plate
Cover
Fig. 13
Turn table
Stopper
Publicité
Table des Matières
