Pictgraph Illustration And Explanation - Hitachi VB 13Y Mode D'emploi Et Instructions De Securite

PICTGRAPH ILLUSTRATION AND EXPLANATION

Read handling
instructions before use.
Begin operation only after
ensuring that there are no
people within the turning
range of the material to be
bent.
Never bring your hand
close to the cutter during
operation.
Do not this electric power tools
in wet wether conditions.
Avoid any work exceeding
the maximum capacities.
Rebar diameter ø 13mm (#4, 1/2")
If you put your hand on the rebar when it is bent
at a large angle, there is a risk of your getting
the hand caught in the bent rebar. Make
absolutely sure that you put your hand off the
position where the rebar is bent.
English
If the switch is turned off
and then immediately
turned on again, the
motor may not start.
Wait for at least one full
second before
attempting to turn the
motor on again after it
has been switched off.
Do not attempt to cut
two rebars at one time.
13