Technical Specifications - HQ Power XML12 Notice D'emploi

• Only use the PSU and the garland for their intended purpose. Use in an
unauthorised way will void the warranty.
• Damage caused by disregard of certain guidelines in this manual is not
covered by the warranty and the dealer will not accept responsibility for
any ensuing defects or problems.
4. Installation
Remove the garland from the packaging and open out. Hang the garland.
Connect the power plug of the garland to the PSU and screw the coupling
ring tightly (refer to the illustration on page 2 of this manual). Plug the PSU
to the mains. Disconnect from the mains and store in the packaging after
use.

5. Technical Specifications

LEDs
power supply
PSU
power consumption
IP rate
working temperature
length power cord
length LED wire
weight
Use this device with original accessories only. Velleman nv cannot be
held responsible in the event of damage or injury resulted from
(incorrect) use of this device. For more info concerning this product
and the latest version of this manual, please visit our website
www.hqpower.eu. The information in this manual is subject to
change without prior notice.
© COPYRIGHT NOTICE
The copyright to this manual is owned by Velleman nv. All worldwide
rights reserved.
No part of this manual or may be copied, reproduced, translated or reduced
to any electronic medium or otherwise without the prior written consent of
the copyright holder.
16.07.2010
XML12/XML13
XML12
180, warm white
24 V, 450 mA
240 VAC~50 Hz
10.5 W
-15°C~60°C
± 160 g
4
XML13
160, warm white
24 V, 400 mA
8.4 W
IP44
5 m
2 m
± 550 g
©Velleman nv