Setting Mode - TFA AIRCO2NTROL COACH Mode D'emploi

TFA_No. 31.5009_Anleitung 06.11.2018 16:57 Uhr
AIRCO NTROL COACH – CO Monitor
2 2
7.1.2 „AL"
In this mode, the red display illumination is activated as an optical signal in the event of an alarm
when the limit value (default> 1400 ppm) has been exceeded.
You can set the alarm limit value in setting mode.
7.1.3 „on"
In this mode, you can set the display illumination to a single colour.
Choose between 7 colours in setting mode.
7.1.4 „OFF"
The backlight is off in this mode.

7.2 Setting mode

• Press and hold the MODE button for 3 seconds. SEL COL appears and you can use the + button to select
the display illumination colour for the "on" mode.
1 = WHITE
2 = LIGHT BLUE
3 = DARK BLUE
4 = PURPLE
5 = RED
6 = YELLOW
22
Seite 12
AIRCO NTROL COACH – CO
2
7 = GREEN
• Confirm with the MODE button.
• "AL" appears and the default setting is 1400 ppm.
• Use the + button to set the desired alarm limit (400 to 3000 ppm) in increments of 100 for the "AL" mode
• Confirm with the MODE button.
• The time appears on the display. The hour digits flash.
• Press the + button to adjust the hours.
• Press the MODE button again and set minutes in the same way.
• Confirm with the MODE button.
• "ECO L" appears and the default setting is OFF. If the ECO LIGHT function is activated, the light is dimmed
between 22:00 and 6:00. Please set the actual time to use this function.
• Press the + button to activate (ON) or deactivate (OFF) the function.
• Confirm the setting with the MODE button to return to normal mode.
• The device will automatically quit the setting mode if no button is pressed for 20 seconds.
8. Display section HISTORY
• The graph shows the measured CO
• The bar on the position "0 h" always corresponds to the current measured value of the CO
bar is updated every 10 seconds, together with the measured value).
Monitor
2
values of the last 24 hours clearly.
2
level (the
2
23