brennenstuhl L801 IP 55 Guide D'utilisation page 6

User Manual
Installation / Wiring
• Loosen the screws to remove the base plate.
• Use the base plate to mark the drill holes in the desired location.
Drill the marked holes and ensure not damaging hidden pipes or cables.
• Feed the mains power cable through the rubber grommet.
• Secure the base plate with suitable wall plugs and fasteners in the
desired location.
• Observe the cable diagram for wiring and ensure proper connection
of cables and screws.
Power supply
Earth
(green/yellow)
Neutral
(blue)
Phase
(black or brown)
This light must be earthed!
• Replace the light with the two cap screws on the base plate.
Maintenance instructions:
Do not open the LED unit. The LEDs cannot be replaced.
Any contact can damage the LEDs.
Immediately replace a damaged protective cover. Do not use the light
without flawless protective cover. Clean light and motion detector with
a damp cloth, if necessary. Do not use any chemicals or aggressive
agents for cleaning the device.
L801 PIR IP 55 only:
Light system setting
At the bottom there are 2 control knobs.
6
L801 IP 55 / L801 PIR IP 55
To fitting
Earth
(green/yellow)
Neutral
(blue)
Phase
(black or brown)