Instruction Manual - Gardigo 70045 Notice D'utilisation

SOLAR MOLE REPELLER DIAMOND

Instruction manual

Art.-No. 70045
Dear client,
thank you for choosing one of our quality products. In the
following, we will explain the functions and operation of our
product. Please take the time to read through the instruc-
tions carefully. Please take some time to read through the
instructions carefully. Please note all the included safety and
operating instructions. Keep this manual safe and ensure
that you include it when passing on the product on to a third
party. If you have any questions or suggestions about this
product, please contact your supplier or our service team.
We would appreciate it if you would recommend us to others,
and we hope you enjoy using this unit.
1. Product description
This animal repeller device is one of the new generation of
repellers! It generates quartz vibrations in approx. 60 sec in-
tervals (OFF: 57 sec, ON: 3 sec) within a frequency range of
400 – 1000 Hz ± 50 Hz. Outdoor test showed that these spe-
cially generated vibrations have an optimum effective area
of approx. 1250 m², depending on condition of soil. Because
the tone frequencies and vibrations are intolerable for many
soil animals, they migrate to other areas within just a few
days. Other useful animals are not harmed. The Solar Animal
Repeller can be used in the garden, in the field or in other
outdoor areas with unwanted rodents. The finely tuned elec-
tronic components and the efficient solar modules guarantee
constant function even with poor light. This appliance not
only repels rodents and ants!
2. Installation and maintenance
Remove the plastic foil in the transparent part of head of
the product before using (battery is on power now). Insert
the device into the ground, so that up to ¾ of the aluminium
stake is beneath the surface. To start up, select the operating
mode on the underside of the housing. The animal repellent
device is now ready for operation. Check the function of the
device regularly. In case it does not work normally any more, a
6
replacement of the rechargeable battery might be necessary
(see point 3).
Operating modes:
1. [Press once] Tone frequency
2. [Press twice] Vibration motor
3. [Press 3 times] Tone frequency + vibration motor
(Parallel operating mode)
4. [Press 4 times] Tone frequency + vibration motor
(Alternate operating mode)
5. [Press 5 times] Switch off the device
3. Replacement of the rechargeable battery
1. Remove the transparent housing cover.
2. Carefully take off the solar panel from the rechargeable
battery which is underneath. When doing so, make sure
that the cable connection between the solar panel and the
circuit board which is underneath the rechargeable battery,
is left intact and is not damaged.
3. Remove the old rechargeable battery from its fitting.
4. Insert a new rechargeable battery size Mignon (AA) and
type Ni-MH with 1.2 V and 850 mA. When doing so, mind
the correct polarity as shown on the bottom inside the bat-
tery fitting.
5. Carefully place the solar panel back on the rechargeable
battery.
6. Reattach the transparent casing cover to the casing body.
4. Technical data
• Effective area:
approx. 1250 m², depending on condition of soil
• Frequency: approx. 400 – 1.000 Hz ± 50 Hz, self-controlling
• Interval: approx. 3 sec on, approx. 57 sec off (break interval)
• Vibrations
• Solar panel: Polycrystalline solar cells
• battery powered, solar powered
• Voltage reserve: up to 7 days without exposure to light
• Batteries: 2 rechargeable batteries (AA), type Ni-MH,
1.2 V, 850 mA (included); can be replaced if necessary
• On-/off switch
Status: 05/17