Maintenance Of The Extractor; Remove The Inlet Grille; Replace Inlet Grille; Cleaning The Grease Filter - Novy Easy 1851 Mode D'emploi

Discolouration of the hob does not have any influence on the
operation or strength of the vitro­ceramic. It is not a form of
damage to the hob, but it is a result of residues that have not
been removed and have therefore burnt­in.
Shiny spots occur as a result of wear caused by the base of the
pans, in particular when using cooking pans with an aluminium
bottom or when using the wrong cleaning agents. These can
only be removed with great difficulty using common cleaning
agents. If necessary, repeat the cleaning several times.
Due to the use of aggressive cleaning agents and scratching
caused by the pan bases, the glass surface is rubbed off over
the course of time, leaving dark stains.
Do not use the cooking plate as a table top or for putting
utensils on.
Always lift up the pans/pots and do not slide them along the
glass plate.

8.2 Maintenance of the extractor

8.2.1 Remove the inlet grille


Do not use any objects that could damage the
inlet grille, such as potscourers, scouring agents
or aggressive cleaning agents.

First switch off the hob and the delay before
removing components from the extractor.
– Press on the right of the inlet grille until it tilts.
– Grasp the inlet grille and put it aside safely on the kitchen
worktop.

Do not place the inlet grille on the hob glass to
avoid scratches. Do not place the inlet grille on
a hob that has been switched on to prevent it
heating up.

8.2.2 Replace inlet grille


Take care that the Monoblock filter and grease
filter have first been placed in the appliance
before replacing the inlet grille.
– Grasp the inlet grille and insert it in the centre of the extraction
opening in line with the position marks.

8.2.3 Cleaning the grease filter

When the grease filters need to be cleaned, this is indicated by
the grease filter cleaning indicator (see 4.5.1)
– Remove the inlet grille (see 8.2.1)
– Grasp the grease filter by the grips and lift it out of the
extraction opening
Wash in the dishwasher or submerge in hot water with anti-
grease dishwashing liquid.

WARNING: If the instructions above are not
carried out, serious soiling can cause a fire
hazard.
After cleaning:
– Using the grips, replace the grease filter in the right direction
in the extraction opening.
– Replace the inlet grille in the extraction opening
– Reset the grease filter indicator (see 6.1)
– 54 –