Spektrum AR7010 Guide De L'utilisateur page 8

EN
IMPORTANT: When using Y-harness or servo extensions it' s important to use
standard non-amplified Y-harnesses and servo extensions as this can/will cause
the servos to operate erratically or not function at all. Amplified Y-harnesses were
developed several years ago to boost the signal for some older PCM systems and
should not be used with Spektrum equipment. Note that when converting existing
models to Spektrum be certain that all amplfied Y-harnesses and or servo extensi-
ons are replaced with conventional non-amplified versions.
Binding
The AR7010 receiver must be bound to the transmitter before it will operate.
Binding is the process of teaching the receiver the specific code of the transmitter
so it will only connect to that specific transmitter.
1. To bind an AR7010 to a DSM2 or DSMX transmitter, insert the bind plug in the
BIND/DATA port on the receiver.
To bind an aircraft with an electronic speed controller that powers the receiver
through the throttle channel (ESC/BEC), insert the bind plug into the BIND/DATA
port in the receiver and the throttle lead into the throttle (THRO) port. Proceed to
Step #2.
2. Power the receiver. The LED on the receiver should be flashing, indicating that
the receiver is in bind mode and ready to be bound to the transmitter.
3. Move the sticks and switches on the transmitter to the desired failsafe positions
(low throttle and neutral control positions).
8