Setting The Baud Rate; Setting The Sync Output Signal - Sony PC-3000 Mode D'emploi

Adjustments and Settings on the Display Window Adjustments and Settings in the Service Mode

Setting the Baud Rate

You can select the baud rate setting from RS-422A/
232C, PC COM, 9600bps, 19.2kbps and 38.4kbps.
1
Enter the service mode and press the CONTROL
button.
2
Press the > or . button until the CONTROL
MENU BAUD RATE SETTING display appears.
CONTROL MENU S
BAUD RATE SETTING
3
Press the SET button.
BAUD RATE SETTING S
>422A / 232C >38.4k
4
Press the ? or / button to move flashing.
To set to RS-422A/232C or PJ COM: flash the
left item (ex. 422A/232C).
To set to 9600bps, 19.2kbps or 38.4kbps: flash
the right item (ex.38.4k).
5
Press the > or . button to set the baud rate.
The set item is flashing.
6
Press the SET button to enter the setting.
28
(EN)

Setting the Sync Output Signal

You can set the sync output signal to the output signal
of this unit.
1
Enter the service mode and press the CONTROL
button.
2
Press the > or . button until the CONTROL
MENU SYNC OUT SETTING display appears.
CONTROL MENU S
SYNC OUT SETT I NG
3
Press the SET button.
SYNC OUT SETT I NG S
>THRU >C. SYNC
4
Press the ? or / button to move flashing.
To output the loop-through signal: flash THRU.
To output the composite sync signal: flash C.
SYNC.
5
Press the SET button to enter the setting.