Setting The Audio Output Level; Displaying Information About The Attached Extension Board - Sony PC-3000 Mode D'emploi

Adjustments and Settings on the Display Window
To clear the name
1
Press the ? and / buttons simultaneously for at
least five seconds in the TITLING display.
The following message appears.
RESET DATA?
>YES >NO
2
Press the ? or / button to flash YES and then
press the SET button.
The following message appears.
DATA
>ALL SW >SW1–2
3
Press the >, ., ? or / button to select the
channel name to be cleared.
To clear the name of all channels: press the ?
or / button to flash ALL SW.
To clear the specified channel name: press the
? or / button to flash SW 1-2 (ex. "1-2")
and the > or . button to select the channel to
be cleared.
4
Press the SET button to enter the setting.
18
(EN)

Setting the Audio Output Level

You can set the audio level of the selected channel.
1
Turn on the power.
2
Press the CONTROL button.
3
Press the > or . button to select the CONTROL
MENU AUDIO LEVEL.
CONTROL MENU
AUD I O LEVEL
4
Press the SET button.
The AUDIO LEVEL setting display appears.
AUD I O L EVE L CH 1–2
> pppppppppp <
5
Adjust the audio output level.
There are 10 audio output levels.
> or / button: press to increase the level.
. or ? button: press to decrease the level.
6
Press the SET button to enter the setting.
Displaying Information About the
Attached Extension Board
1
Turn on the power.
2
Press the CONTROL button.
3
Press the > or . button until the CONTROL
MENU EXB INFO. display appears.
CONTROL MENU
EXB I NFO.
4
Press the SET button.
The information of the attached signal interface
board appears.
SLOT 1 EXB–5010
SLOT 2 NO EXB