Note From The Manufacturer; Before Installation; Grounding Instructions - Leviton EVR30 Manuel D'installation

NOTE FROM THE MANUFACTURER

This document provides instructions for the Evr-Green
be used for any other product. Before installation or use of this product, you should review this
manual carefully and consult with a licensed contractor, licensed electrician, or trained installation
expert to make sure of compliance with local building codes and safety standards.

BEFORE INSTALLATION

INSTRUCTIONS PERTAINING TO THE RISK OF ELECTRIC SHOCK
• Read all the instructions before using this product.
• This device should be supervised when used around children.
• DO NOT put fingers into the electric vehicle connector.
• DO NOT use this product if the flexible power cord or EV cable are frayed, have broken
insulation, or any other signs of damage.
• DO NOT use this product if the enclosure or the EV connector is broken, cracked, open, or
shows any other indication of damage.
• A device employing pressure terminal connectors for field wiring connections shall be
provided with instructions specifying a range of values or a nominal value of tightening torque
to be applied to the clamping screws of the terminal connectors.
CAUTION:
To reduce the risk of fire, connect only to a circuit provided with below amperes maximum
branch circuit over-current protection in accordance with the National Electrical Code, ANSI/NFPA 70.
CAT. NO.
EVR40
EVR30

GROUNDING INSTRUCTIONS

The Charging Station must be connected to a grounded, metal, permanent wiring system; or an
equipment grounding conductor must be run with the circuit conductors and connected to the
equipment grounding terminal or lead on the product.
CIRCUIT BREAKER RATING
50A
40A
www.leviton.com/evrgreen
series Charging Stations and should not
®
2