Important Safety Instructions; Warnings And Cautions - Leviton EVR30 Manuel D'installation

IMPORTANT SAFETY INSTRUCTIONS - SAVE THESE INSTRUCTIONS

WARNINGS AND CAUTIONS:

• TO AVOID FIRE, DEATH, OR INJURY, CAREFULLY READ THE CHARGING
INSTRUCTIONS IN YOUR VEHICLE'S MANUAL BEFORE CHARGING, AND HEED
THE FOLLOWING WARNINGS:
- DO NOT use the EVSE Charging Station with a damaged AC outlet.
- DO NOT use an extension cord to provide power to the EVSE Charging Station.
- DO NOT operate the EVSE Charging Station with a visibly damaged AC Supply
Plug or Charge Cord/Connector. Inspect equipment before each use. If any damage
is detected, contact Customer Support.
• This device shall be mounted at a sufficient height from grade such that the height of
the storage means for the coupling device is located between 24 inches (600 mm ) and
4 feet (1.2 m) from grade.
• Ensure that the Charge Cord is positioned so it will not be stepped on, tripped over, or
otherwise subjected to damage or stress. Always stow the EVSE Charging Station in
a safe place after each use.
• Use this EVSE Charging Station to charge electric vehicles equipped with an SAE
J1772™ compliant charge port ONLY. Refer to the vehicle owner's manual to determine
if the vehicle is equipped with an SAE J1772™ compliant charge port.
• DO NOT attempt to repair or service the EVSE Charging Station yourself. Refer to the
Troubleshooting section, or Customer Support section for service information.
• Retain this guide for future reference.
WARNING:
DANGER OF ELECTRICAL SHOCK OR INJURY. TURN OFF POWER AT THE
PANELBOARD OR LOAD CENTER BEFORE WORKING INSIDE THE EQUIPMENT OR
REMOVING ANY COMPONENT. DO NOT REMOVE CIRCUIT PROTECTIVE DEVICES OR ANY
OTHER COMPONENT UNTIL THE POWER IS TURNED OFF.
CAUTION:
DISCONNECT ELECTRICAL POWER PRIOR TO INSTALLING THE CHARGING
STATION. FAILURE TO DO SO MAY CAUSE PHYSICAL INJURY OR DAMAGE TO THE
ELECTRICAL SYSTEM AND CHARGING UNIT.
The Charging Station shall be installed only by a licensed contractor, and/or a licensed electrician
in accordance with all applicable state, local and national electrical codes and standards.
Before installing the Charging Station, review this manual carefully and consult with a licensed
contractor, licensed electrician and trained installation expert to ensure compliance with local
building practices, climate conditions, safety standards, and state and local codes.
Use appropriate protection when connecting to the main power distribution cable.
1 www.leviton.com/evrgreen