Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
> Replacing the blade
For safety reasons, we recommend having the
blade replaced by an authorized professional.
Important: Wear work
Replacement blade, as this will ensure top
performance and safety under all conditions. Carry
out the following steps to change the blade:
§ Turn the mower onto its side.
§ Grip the blade( C) with one hand.
§ Use a wrench (not supplied) to loosen and remove
the blade nut (B).
§ Replace the blade
§ Securely tighten the blade nut.
STORAGE
Always clean your mower before storage. Store
your mower in a clean, dry environment.
To avoid mould on remaining contents, make sure
the grass collect bag is empty and dry.
You can fold the handle to save space, loosen the 2
clamps on each side of the handle and
bend the upper handle part towards the front of the
machine.
> Long-term storage:
Apply eco-friendly oil to the mower blade to keep it
from rusting.
> Wintering
Have your blade sharpened after the mowing
season, so the machine is ready for the new
season.
TECHNICAL DATA
Rated Voltage
Rated Frequency
Rated Power
Rotation speed
Cutting width
Blade
Protection class
Int. protection degree
Collect box / bag
Cutting heights
Induction motor
Weight
Noise emission values measured according to
relevant standard :
Acoustic pressure level L
80.1 dB(A)
Acoustic power level L
WA
92.2 dB(A)
Guaranteed sound power level L
«
Fig E »
gloves!
230-240 V
50Hz
1300W
3450 min
-1
32 cm
ZP6120
Class II
IPX4
30 L
25/45/65 mm
No
6.9 Kg
PA
K = 3 dB(A)
K = 2.02 dB(A)
96 dB(A)
WA
The sound power pressure may
exceed 85 dB(A), in this case
individual hearing protection
Weighted root mean square acceleration according
to relevant standard. :
2
3.24 m/s
K = 1.5 m/s²
The declared vibration total value has
been measured in accordance with a standard
test method and may be used for comparing one
tool with another that the declared vibration total
value may also be used in a preliminary
assessment of exposure.
A warning that the vibration emission
during actual use of the power tool can differ
from the declared total value depending on the
ways in which the tool is used and of the need to
identify safety measures to protect the operator
that are based on an estimation of exposure in
the actual conditions of use (taking account of
all parts of the operating cycle such as the times
when the tool is switched off and when it is
running idle in addition to the trigger time).
SERVICE DEPARTMENT
_ Damaged switches must be replaced by our after-
sales service department.
_ If replacing the power cord is necessary, it
should be done by the manufacturer or his agent
to avoid a hazard.
AFTER-SALES SERVICE AND
APPLICATION SERVICE
Our after-sales service responds to your questions
concerning maintenance and repair of your product
as well as spare parts. Exploded views and
information on spare parts can also be found
under:www.eco-repa.com
ELEM GARDEN TECHNIC application service team
will gladly answer questions concerning our
products and their accessories :
ATTENTION !
must be worn.
sav@eco-repa.com
41
Publicité
Table des Matières
