elem Garden Technic TDE3213CBE21 Traduction Des Instructions D'origine page 43

TROUBLE SHOOTING
The following chart lists problem symptoms, possible causes and corrective action, if your machine does not
operate properly. If these do not identify and correct the problem, contact your service agent :
Problem
Machine fails to
operate
Problem
Machine functions
intermittently
Problem
Machine leaves ragged
finish
Or motor labours
Problem
Cutting blade not
rotating
while machine switched
on
Problem
Excessive
vibration/noise
You can request the instruction manual in PDF format by email:
Before any intervention on the appliance, disconnect the mains plug.
Cause
Power turned off
Mains socket faulty
Extension cable damaged
Mower in long grass
Cause
Extension cable damaged
Cause
Height of cut too low
Cutting blade blunt
Underside of machine badly clogged
Blade fitted upside down
Cause
Cutting blade obstructed
Blade nut/bolt loose
Cause
Blade nut/bolt loose.
Cutting blade damaged
Made in China
Warning !
Turn power on.
Use another socket
Inspect cable, replace if damaged
Increase height of cut and tilt mower
Inspect cable, replace if damaged
Action
Increase height of cut
(see "Height of Cut Adjustment")
Replace blade
(see "Blade Maintenance")
Clean machine
(see "After Mowing/Storage")
Refit blade correctly
(see "Blade Maintenance")
Clear obstruction
Tighten blade nut/bolt
Tighten blade nut/bolt
Replace blade
info@eco-repa.com
2020
info@eco-repa.com
Action
Action
Action
Action
43