Care & Maintenance; Cleaning; Storing; Resetting The Motor Thermostat - Ninja FOODi HB150C Guide De L'utilisateur

CARE & MAINTENANCE
IMPORTANT: Review all warnings on
pages 4–5 before proceeding.

CLEANING

Allow parts to cool before cleaning.
Separate all parts before cleaning.
Hand-Washing
Wash the pitcher, lid, and tamper with
warm, soapy water. Use the included
cleaning brush to avoid direct contact
with the blades.
NOTE: DO NOT submerge the blender
pitcher. Submerging will damage the
integrated heating element.
Dishwasher
The lid, center cap, and tamper are
dishwasher safe.
NOTE: DO NOT wash the blender pitcher
in the dishwasher. Dishwashing will
damage the integrated heating element.
Motor Base
Press the power button to turn off the
unit, then unplug the motor base. Wipe
motor base with a clean, damp cloth.
CLEAN
A combination of heat and rapid pulses
easily removes residue from the nonstick
coating in minutes.
1 Fill pitcher with 24 oz. of water and
2 small drops of dish soap.
2 Place the lid on the pitcher and ensure it
is properly closed.
3 Press CLEAN.
4 When program is complete, discard
water and thoroughly rinse pitcher.
TIPS FOR BEST CLEANING RESULTS:
• Give the pitcher a quick rinse before
running CLEAN.
• Run CLEAN immediately after use.
12 12
ninjakitchen.com

STORING

Store the unit upright with the lid secured
on the pitcher.
NOTE: DO NOT stack items on top of the
unit. Store any remaining attachments
alongside the unit or in a cabinet where they
will not be damaged or create a hazard.
RESETTING THE MOTOR
This unit features a unique safety system
that prevents damage to the motor by
temporarily disabling the motor if it begins
to overheat. Should this occur, follow the
reset procedure below.
1 Unplug the unit from the electrical outlet.
2 Allow the unit to cool for approximately
15 minutes before using.
IMPORTANT: Ensure that maximum
capacities are not exceeded. This is the
most typical cause of appliance overload.

ORDERING REPLACEMENT PARTS

To order additional parts and attachments,
visit ninjaaccessories.com.
DISPLAY SCREEN & ERROR MESSAGES
DISPLAY SCREEN MESSAGES
"Lid"
The lid is not assembled correctly. Be sure
the lid is on the pitcher and locked in place
before running a program.
"JAr"
The pitcher is not properly attached to
the base. Be sure the pitcher is secured
in the base before selecting a program.
"---" Blinking
You are attempting to run a program
too many times in a row. For your safety,
certain programs may be run only 2
consecutive times.
NOTE: DO NOT attempt to remove the
pitcher while the blender is running. Wait
for the blades to stop spinning before
removing the pitcher.
ERROR MESSAGES
"E01" or "E02"
Remove and reinstall the pitcher. If that does
not solve the issue, contact Customer Service
at 1-877-646-5288. So we may better assist
you, please register your product online at
registeryourninja.com and have the product
on hand when you call.
ninjakitchen.com
13 13