Operation - REICH Move Control Economy 527-0500 Instructions D'assemblage Et Mode D'emploi

6. Operation

B1 Turn ON the isolation switch.
Make sure that both drive units have
been disconnected from the vehicle tyres.
B2 Activate the MoveControl by double-clicking
the I/O button on the remote control. The LED
on the remote control will show you that the
MoveControl is ready for operation.
Check the function of the MoveControl by
pushing the buttons on the remote control.
B3 Turn off the MoveControl by pushing the I/O
button once. The LED of the remote control
will go out. Attention: if the motors don't work,
either the unit must be reset or the remote
control may have to be re-adjusted to the
receiver (Basic Station).
B4 Take your caravan or trailer outdoors. We
suggest you choose a large area with
sufficient safety margin to people and objects
until you have enough experience in operating
the MoveControl.
B5 Put a suitable key or adapter (19 mm) on the
hexagonal bolt. Turn the spindle as long
enough until you can see the green marking
completely
mechanical stroke signals the respective final
position.
ON
B6 Undo the handbrake of your caravan.
B7 Activate the MoveControl with a double-click
on the I/0 button at the remote control. The
LED will light up.
Now you can execute the movements according
to the symbols shown on the remote control.
GB6
(= OFF). An additional
For the removal disconnect the drive units in
reverse order as described.
Ensure that the friction rollers are completely
driven back and the green marking can be seen
7
no more (= OFF).
OFF
The drive units must not be left connected to the
tyres for long periods of time, as this can result in
damage to the tyres. Movement with a motor
vehicle while the drive units are connected is not
allowed, as the caravan or trailer as well as the
motor vehicle can be damaged.
Turn OFF the isolation switch
Pull on the handbrake and/or secure your caravan
or trailer against rolling away with the help of
chocks.
.