Remote Control; Security Advice - REICH Move Control Economy 527-0500 Instructions D'assemblage Et Mode D'emploi

7. Remote control

Activate the MoveControl by double-
clicking the I/O button on the remote
control - the LED is ON.
Now you can execute the movements
according to the symbols shown on the
remote control. The vehicle only moves
as long as you keep the buttons pushed
down.
The integrated "Soft-Start" gives an acoustic
signal when starting to move which is meant as a
warning signal of a caravan or trailer starting to
move.
The movement buttons have to be pressed
respectively one by one. The arrows by the
buttons show the respective direction of motion.
Forward
Curve drive:
Left wheel
forward
Left wheel
backward
Rotation
(pushing 2 buttons simultaneously) :
+
Clockwise rotation
+ Anti clockwise rotation
Turn off the MoveControl by pushing the
I/O button once at the remote control. The
red LED will turn OFF.
If the movements do not correspond to the
symbols on the remote control, the cable
connections of the right and the left drive units
need to be checked and - if necessary -
exchanged (see wiring diagram
It is important that in such a case you turn the
isolating switch off and disconnect the electronic
box from the electricity supply.
If you experience radio interference you can
connect the cable the cable between handset and
the Basic Station.
Backward
Right wheel
forward
The cable also can be used if the battery of the
remote control is used up.
Right wheel
backward

Security advice:

).
Make sure that you never exchange
the Positive (+) and Negative (-) of
the electricity supply.
Basic Station
Be careful that no one is in the
moving area while manoeuvring the
caravan!
Also check on the side of the
caravan which turned away from
you.
Keep a safe distance during moving.
Always keep sufficient distance of
the friction rollers after maintenance
or cleaning.
Switching plant absolutely current-
freely and safeguarding
against roll away at works in the
area of the friction rollers.
vehicle
GB7