Wagan Tech Smart AC 150 USB+ Guide D'utilisation page 4

Smart AC 150 USB+ by Wagan Tech
® ™
4. Make sure the battery's voltage does not exceed 16 volts
DC. CONNECTING THE INVERTER TO A DC POWER SOURCE
GREATER THAN 16V WILL VOID THE WARRANTY, AND MAY
DAMAGE THE INVERTER.
Troubleshooting
If the inverter does not appear to be functioning properly, there are
several reasons why the inverter may not be responding:
Problem Solution
Poor contact Clean contact parts thoroughly
Receptacle Check car fuse, replace damaged fuse. Check receptacle
has no power wiring. Repair if necessary.
Fuse is blown The fuse is located inside the DC plug. Replace fuse with a
fuse of equivalent value.
Battery Start the engine to recharge the battery, replace battery if
voltage is too needed.
low
Shut down on Reduce the wattage of your load to lower than 150 watts.
overload
Thermal Under heavy loads for extended periods of time, the inverter
shutdown will shut down to prevent damage due to excess heat. Simply
reduce your load and allow the inverter to cool down.
Low-battery Recharge your battery and resume operation. If you appear
shutdown to have a problem which is not listed above, you may call our
customer service department.
www.wagan.com
5
®
User's Manual—Read before using this equipment
NOTE: All specifications typical at nominal line, half load, and 77°F
(25°C)unless otherwise noted. Specifications subjected to change
without notice.
Specification
™
TrueRated Power
Peak Surge Power
AC Output
USB Output
DC Input
No Load Current
Output Waveform
Efficiency (Full Load)
Weight
©2012 Wagan Corporation. All Rights Reserved.
Wagan Tech and wagan.com are trademarks used by Wagan Corporation.
150 W
300 W
110 V, 60 Hz
5 V, 2.1 A
12 V nominal (10 V to 15 V)
< 0.15 A
Modified Sine Wave
Approximately 90%
162 g
6