Range Hood Use; Kwvu Model Series; Gz And Ih Model Series; Range Hood Care - KitchenAid KWVU265YBA Instructions D'installation Et Guide D'utilisation Et D'entretien

The range hood is designed to remove smoke, cooking vapors
and odors from the cooktop area. For best results, start the hood
before cooking and allow it to operate several minutes after the
cooking is complete to clear all smoke and odors from the
kitchen.

KWVU Model Series

A
A. Light button
B. Speed buttons
Operating the Fan
1. Slide the shelf forward.
2. Press the speed buttons for the desired speed.
Speed may be increased, decreased, or turned off at anytime
during the vent hood operation. The indicator light next to the
speed button selected should be on when the fan is running.
3. Press the 0 button or close the shelf to shut off the fan.
The fan will shut off when the shelf is about 2" (5.1 cm) from
the closed position. When the shelf is opened the fan will
operate at the last setting.
Operating the Light
1. Open the shelf about 1" (2.5 cm).
2. Press the light button.
The light will be on each time the shelf is opened. The light
can be used for a night light by opening the shelf about
1" (2.5 cm).
3. Press the light button to turn off the light.
Another option for turning off the vent hood light is to close
the shelf.

Cleaning

Exterior surfaces:
Clean the vent hood with a mild detergent and soft cloth.
Do not use abrasive cleansers or steel-wool pads
Metal Filter:
For the best results, clean the filters often. Pull the tabs
downward to remove filters. Place filters in dishwasher or hot,
soapy water to clean.

Replacing the Bulb

1. Use a 15-watt fluorescent bulb with 30" (76.2 cm) unit and
18-watt bulb with 36" (91.4 cm) unit.
2. Remove the screws above the light cover and set them aside.
3. Pull the light cover forward slightly and then downward to
remove the cover.

RANGE HOOD USE

B

RANGE HOOD CARE

GZ and IH Model Series

A
A. Light switch
B. Fan switch
C. Indicator light
D. Speed switch
Operating the Fan
1. Slide the shelf forward.
2. Move the fan switch to 1.
3. Move the speed switch to the desired setting.
The speed may be increased, decreased, or turned off at
anytime during the vent hood operation. The indicator light
should be on when the fan is running.
4. Move the fan switch to 0 or close the glass shelf.
The fan will shut off when the shelf is about 2" (5.1 cm) from
the closed position. When the shelf is opened, the fan will
operate at the last settings.
Operating the Light
1. Open the shelf about 1" (2.5 cm).
2. Move the light switch to the 1 position.
The light will be on each time the shelf is opened. The light
can be used for a night light by opening the glass shelf about
1" (2.5 cm).
3. Move the light switch to the 0 position.
Another option for turning the vent hood light off is to close
the shelf.
4. Replace the light bulb.
5. Lift cover back into position.
6. Replace the screws.
KWVU Model Series
A. Screws
GZ and IH Model Series
A. Screws
B
C
D
A
A
13