Operating Instructions - Skil SC5364-00 Guide D'utilisation

OPERATING INSTRUCTIONS

WARNING
allow a fluid to flow inside them. Corrosive or conductive fluids, such as seawater, certain
industrial chemicals, and bleach or bleach-containing products, etc. can cause a short circuit.
WARNING
modification is misuse and could result in a hazardous condition leading to possibly serious
personal injury.
How to Charge the Battery Pack
NOTICE: The battery pack is shipped partially
charged. Before using it the first time, fully
charge the battery pack.
a. Charge the battery pack with the correct
charger.
b. Connect the charger to a power supply. All
indicators on the charger will flash once
together, indicating that the charger self-
inspection is completed.
c. Align the raised ribs of the charger with the
slot in the battery pack.
d. Insert the battery pack into the charger.
e. The charger will communicate with the
battery pack to evaluate the condition of the battery pack.
f. If the battery pack temperature is within the charging-temperature range, the charger will
automatically start charging the battery pack. The green charging indicator will flash during
charging. The fuel gauge on the battery pack will flash according to the current battery
charge status.
Battery Charge Status
<25%
25%~50%
50%~75%
≥75%
g. After the charging is complete, the green charging indicator will remain green, without
flashing. And the fuel gauge LEDs on the battery pack will turn off. Remove the battery pack
from the charger and disconnect the charger from the power supply.
h. A flickering red defect indicator indicates a defective battery or a bad connection between
the battery and the charger. Remove and reinstall the battery.
i. A solid red defect indicator indicates that the battery is over or under the optimal
temperature. Remove the battery pack from the charger. If the battery is too hot, cool
the battery under air flow. If the battery is too cold, place it indoors until it reaches room
temperature.
j. It is not recommended that the battery pack remain on the charger for more than 24 hours.
NOTICE: If the battery pack cannot accept a charge, the contacts of the charger or battery
pack may be contaminated. Clean the contacts of the charger or battery pack (e.g., by
inserting and removing the battery several times or cleaning with a cotton swab and alcohol)
or replace the battery pack, as required.
10
To reduce the risk of fire, personal injury, and product damage due to
a short circuit, never immerse your charger or battery pack in fluid or
Do not attempt to modify the charger or create accessories not
recommended for use with this charger . Any such alteration or
Fig. 2
Fuel Gauge
Last segment flashing, rest solid.
Attach
Detach