Restoring Factory Settings; Troubleshooting - Esoteric Grandioso P1 Mode D'emploi

Restoring factory settings

Settings are retained even if the power plug is disconnected.
Follow these procedures to restore all settings to their factory
defaults and clear the unit's memory.
1
Press the MENU button for at least five seconds.
"Setup CLR?" appears on the display.
2
Press the play (t) button.
The settings are restored to their factory defaults, and "Setup
CLR" (settings cleared) appears on the display.
30 30
Press for at least 5
seconds.

Troubleshooting

If you experience a problem with this unit, please take a moment to
review the following information before requesting service. The prob-
lem could also be something other than this unit. Please also check
the operation of the connected units.
If this unit still does not operate correctly, contact the retailer where
you purchased the unit.
The unit does not turn on.
e Confirm that the power cord is securely connected to both the
inlet on the back of this unit and a power outlet.
e Confirm that power is being supplied to the outlet to which the
power cord is connected by, for example, connecting another
device to it.
e Confirm that the DC power connection cords are properly con-
nected to this unit and the power supply.
e Check if the power source is a switched outlet. If it is, make sure
it is turned on.
The unit automatically turns off.
e This is because the automatic power saving function turned it
off. Turn the unit on again. Change the automatic power saving
function time if necessary (page 29).
Remote control does not work.
e Turn the power unit on (page 18).
e If the batteries are exhausted, replace both of them with new
ones (page 17).
e The remote control will not work if there is an obstruction
between it and the main unit. Point the remote control at the
front panel of the unit from a distance of less than about 7 m (23
ft) (page 17).
Another electronic device is malfunctioning.
e Some electronic devices with wireless remote control functions
might malfunction in response to the operation of this unit's
remote control.
Playback is not possible.
e Load the disc in the center of the tray correctly.
e If the disc is upside down, reload it with the labeled side up.
e If the disc is dirty, wipe it clean (page 9).
e If condensation has occurred inside this unit, turn it on and leave
it for 1-2 hours (page 31).
The unit does not respond when buttons are pressed.
e Multiple button presses without pause can cause the unit to
stop responding. After pressing a button, wait momentarily for
the unit to respond.
There is noise.
e Place the unit as far away as possible from TVs and other devices
that have strong magnetism.