Remote Control Unit; How To Insert The Batteries; Restoring Factory Default Settings - Esoteric P-05 Manuel Du Propriétaire

Remote Control Unit

Notes on use
< Point the remote control unit at the main unit's remote sensor
within seven meters (23 feet) of the main unit. There should
not be any obstacles between the player and the remote
control unit.
< Do not allow direct sun or other light to shine on the remote
sensor part of the main unit. This may cause the remote
control unit to work incorrectly.
< Note that other units with remote controls may operate
incorrectly because of infrared light "overspill" when you
operate this remote control unit.

How to insert the batteries

Remove the cover of the remote control unit with a
screwdriver. After checking the polarity (+/_) of two AA
batteries, insert the batteries, replace the cover and replace
the screws.
Battery Replacement
If the distance required between the remote control unit and
main unit decreases, the batteries are exhausted. In this case
replace the batteries with new ones.
Precautions concerning batteries
< Be sure to insert the batteries with correct positive "+" and
negative "_" polarities.
< Use batteries of the same type. Never use different types of
batteries together.
< Rechargeable or non-rechargeable batteries can be used but
not mixed together. Refer to the precautions on their labels.
< When the remote control unit is not to be used for a long
time (more than a month), remove the batteries from the
remote control unit to prevent them from leaking. If they
leak, wipe away the liquid inside the battery compartment
and replace the batteries with new ones.
< Do not heat or disassemble batteries and never dispose of old
batteries by throwing them in a fire.
10

Restoring factory default settings

If you have made a lot of changes to the setup, and want to
restart from a known set of options, restore the unit to the
factory settings as follows:
1 Turn the unit off and wait 30 seconds or longer.
2
Press the POWER button while holding down the STOP
button.
Release the STOP button when "Setup CLR" appears on the
display.
All memories are erased, and the unit returns to the factory
settings.