Explanations - Becker Centronic TimeControl TC445 Notice D'utilisation

Operating Instructions

Explanations

Manual/Automatic sliding switch
When the sliding switch is switched to MAN, only manual control commands are carried
out (e.g. by pressing the UP, STOP and DOWN buttons).
When the sliding switch is switched to AUTO, automatic control commands are carried
out (e.g. switching time, astro evening function,...)
Transmission control light
A radio signal is indicated by the transmission control light being lit.
If the battery starts running out, the transmission control light flashes during transmis-
sion.
The transmitter power and/or radio range is reduced when the battery is running low. If
the transmission control light is no longer lit when the pushbutton is pressed, the bat-
teries must be changed.
Group
Group control means controlling one or several receivers at the same time. The pro-
grammed group is activated using a single command.
When the EC545 is used, the groups are controlled using six radio channels.
Group pushbutton
The group pushbutton may be used to select up to 5 channels. Operation of the individual
channels is indicated by the relevant LED lighting up.
An additional channel is reserved for the central command. This is allocated automatic-
ally. Operation of the central command is indicated by all five LEDs lighting up.
Note
You can note the programmed groups on the label under the see-through cover.
Operating mode
The time and the current operating mode, e.g. HOLIDAY, can be seen on the display.
OK button
When the OK button is pressed, the currently displayed values are saved.
32