Using The Dispensers - Whirlpool W11339488B Guide D'utilisation

Using the Dispensers

1. For automatic dispensing, open the bulk dispenser drawer
using the handle at the base of the washer. For a single load,
open the single-load dispenser drawer at the top left corner
of the washer and disable the Load & Go
2. Add laundry products as described below.
3. Slowly close the dispenser drawer. Make sure it is
completely closed.
Adding HE detergent to dispenser
Load & Go bulk dispenser
™
Use only High Efficiency (HE)
liquid detergents. The bulk dispensers
will hold about 67.6 oz (2 L) or
33.8 oz (1 L) of liquid HE
detergent, depending on dispenser,
or enough for many loads of laundry.
To Fill Bulk Dispeners:
Open the dispenser drawer by pulling on the handle at the
base of the washer. If desired, the bulk dispensers can be
completely removed from the drawer.
Locate the Load & Go
™
dispenser. Gently pull up on the
tab located on the bulk dispenser
lid to lift the fill door.
Fill to the "MAX" line (see
illustrations at right) with HE
liquid detergent or liquid fabric
softener (1-liter dispenser only).
Close fill door. It will click into place.
Make sure the concentration setting
is correct (see the "Choosing the
Right Detergent" section).
It is recommended that you rinse
out the Load & Go containers when
™
refilling, when changing detergent
types or concentrations, or when
the washer will not be used for an
extended period. For instructions
on cleaning the dispenser cartridge,
see the "Washer Care" section.
For instructions on changing
detergent concentration, see
"Using Your Washer, Step 11.
10
option.
™
Use only High
Efficiency (HE)
detergent.
Tab
bulk
"MAX" line
NOTES:
■ A small amount of water may remain in the single load
dispenser from the previous wash cycle. This is normal.
■ See "About Detergent Concentration" for information on
detergent concentration.
■ When detergent in the bulk dispenser is running low, the
display will show the detergent level (Low).
■ Add single-dose and Oxi-type boosters to the drum before
loading items. See the "Using Your Washer" section.
Adding detergent for a single load
Selector
Use only High Efficiency
(HE) detergent.
Pour a measured amount of HE detergent into detergent
compartment. For powdered detergent, lift the selector
to the high position. For liquid detergent, push down the
selector to the low position.
Do not overfill; adding too much detergent may cause
detergent to be dispensed into the washer too early.
Powdered detergent:
Lift the selector to the high
position. Add directly to the
compartment.
IMPORTANT:
■ Disable Load & Go dispenser(s) as desired (see Step
™
11 in "Using Your Washer").
■ Do not add single-dose laundry packet to dispenser
drawer.
HE detergent
compartment
Liquid detergent:
Push down the selector
to the low position. Add
directly to the compartment.