Display Illumination - geo-FENNEL FR 75-MM Mode D'emploi

EN
D
OPERATION
POWER ON
Press the ON/OFF button once to power on the receiver.
The LCD display will initialise for about 0.5 seconds when
all the display symbols are illuminated. A double beep will
sound. The receiver is now ready for use (see right diagram).
SELECT THE DETECTION ACCURACY
Power on the unit and select the detection accuracy fine or normal
by pressing the „accuracy button" .
Fine detection: ± 1 mm (working at close distance)
Normal detection: ± 3 mm (working at far distance)
The display will show the symbol of the accuracy setting made
POWER ON /OFF THE SOUND
Power on the receiver and press the button „sound" to power
on the sound. The symbol in the LCD display shows the status of
the sound: if no symbol is displayed the sound is off.

DISPLAY ILLUMINATION

The display illumination is automatically powered on when powering on the receiver. If the receiver
does not receive a signal for 2 seconds the illumination will power off automatically. Once the unit is
reactivated the display illumination will power on again.
SELECTION OF CLOSE / FAR DISTANCE WORKING
Close distance
Far distance
14
up to 30 m
from 30 m
normal
Close distance / Far distance
fine
on