Assembly Of The Outdoor Unit - Sygonix 1698497 Notice D'emploi

d) Assembly of the outdoor unit
It may be necessary to drill holes at the intended installation position depending on the substrate.
Ensure that you do not damage cables or wires when drilling holes or tightening screws.
Ensure adequate sealing at the point where the cable comes out of the wall so that water running down the
wall (e.g. when it rains) cannot run along the cable into the wall. Use some silicone for sealing.
First, remove the four screws (A) of the top cover (B) and remove them
(note the positions).
Wire the connectors on the back according to the wiring diagram in
Chapter 8. c).
Important!
If the device is operated by a power supply (and possibly an
additional UPS), batteries must not be inserted.
Run the cables down. A seal prevents the penetration of moisture.
Replace the cover (B) and secure it with the four screws (A) that were
previously removed. Ensure the cover is put back on in the right direc-
tion. Only one way is correct (the flattened inside must lie over the ca-
bles).
Mount the wall bracket (A) with two suitable screws
(B) and, if necessary, dowels (C), as shown in the
picture, depending on the condition of the wall.
Place the outdoor unit (D) on the wall bracket (A).
Make sure that the connecting cables are not dam-
aged.
Secure the outdoor unit to the wall bracket using
the supplied special screw (E), the matching tool
(L-key) is included.
If there is a protective film on the cam-
era/LED protective screen, remove it
now.
45