Commissioning The Handset; Insert The Battery Into The Handset; Connecting The Charging Station - Sygonix 1698497 Notice D'emploi

7. Commissioning the handset

a) Insert the battery into the handset
Open the battery compartment on the back of the handset (A) by
sliding the battery compartment cover (D) down.
Then insert the supplied Li-Ion rechargeable battery (B) correctly
into the battery compartment (C). The contacts of the recharge-
able battery must point to the connection contacts in the battery
compartment.
If there is a protective strip over the battery contacts or
if the battery is in a plastic film, remove it first.
Do not use force when inserting the battery; the battery only fits
into the battery compartment in one direction, it can be inserted
easily.
Then close the battery compartment , and slide the battery com-
partment cover (D) back into the handset (A) until it clicks into
place.
b) Connecting the charging station
Connect the circular socket of the supplied
power adapter to the socket on the bottom of the
charging station.
Route the cable back through the provided cable
slot so that it comes out of the opening (20).
If the circular socket and cable are placed cor-
rectly, the charging station can be placed flat on
the table without the charging station wiggling or
tilting.
Place the charging station on a level, stable
surface only. Use an overlay to protect valuable
furniture surfaces from scratches, dents and dis-
coloration.
Connect the power adapter to a mains socket.
The LED (23) will light up.
41