Parts Breakdown; 15073 Border-Edger Kit Installation - EarthQuake MC440 Manuel De L'utilisateur

15073 BORDER-EDGER KIT INSTALLATION (OPTIONAL ACCESSORY)
The Border-Edger Kit is a useful tool for making clean cuts in
the lawn along the borders of gardens, flower beds, walkways,
and driveways for a well manicured look. To install the Border-
Edger Kit, do the following:
INSTALLATION
1. Make sure the cultivator is not running by turning the ON/
OFF switch to the OFF position.
2. Remove the hairpins from both sides of the tine shaft.
3. Remove the cultivating tines from the shaft.
4. Remove the drag stake and lock pin from the unit.
5. Store the tines and save the (2) hairpins; they will be used on
the Border-Edger Kit.
6. Slide the border-edger tine onto either side of the tine
shaft. Make sure that the hub collar of the border-edger tine
faces outward, away from the transmission of the cultivator.
SEE FIGURE 13
7. Take the (2) hairpins saved in Step 4 and insert them through
the inner and outer holes in the tine shaft on each side of the
border-edger tine to secure the tine blade in place on the
shaft. SEE FIGURE 13
8. Slide the border-edger wheel onto the opposite side of the
tine shaft as far as it will go.
9. Insert the remaining (1) hairpin, that came with the kit,
through the inner hole to secure the wheel. SEE FIGURE 13
10. Set the cultivator wheels to the HIGHEST (top) position.
SEE FIGURE 5 (PAGE 12)

PARTS BREAKDOWN

ITEM PART DESCRIPTION
NO. NO.
1 15009 BORDER-EDGER TINE
2 46131 BORDER-EDGER WHEEL
3 46134 HAIRPIN
CAUTION
BE AWARE THAT
UNEXPECTEDLY BOUNCE
FORWARD IF THE
PAVEMENT, OR OTHER HARD SURFACES OR HARD
OBSTACLES BURIED UNDER GROUND.
22
THE CULTIVATOR COULD
UPWARD, OR
TINE STRIKES CONCRETE,
Check for parts online at www.getearthquake.com or call 800-345-6007 M-F 8-5
BORDER-EDGER
WHEEL
HAIR PIN
FIGURE 13
QTY.
1
1
1
JUMP
Operator's Manual
MC440 4-Cycle Cultivator
DRAG STAKE
REMOVED
BORDER-EDGER
TINE
TINE SHAFT
HUB COLLAR