Energy Saving; Electrical Connection - Brandt BIS624ES Manuel D'instruction

maintenance, disconnect your device. Do not
pull the power cord but directly enter the
profile.
Place the unit in a dry and ventilated room.
·
Avoid balconies, porches, decks; excessive
·
heat in summer and cold in winter could
prevent proper operation of your device, or
even damage.
Do not place it near a heat source such as
·
radiator or oven for example.
Keep a minimum distance between your
·
refrigerator and other furniture: 3 to 5 cm on
the sides and 10 cm above for good air
circulation around the unit.
Place the appliance at a suitable distance
·
from the wall using the spacers if they
provided in the accessory bag.
Your appliance has been designed for
·
optimum performance in a room temperature.
We then say that it is designed for a special
"climate class". This climate class is clearly
stated on the rating plate located inside your
appliance, on the left wall down. Beyond these
temperatures, the performance of your
appliance may be reduced.
Classe Temperature
SN from + 10°C to + 32°C
N from + 16°C to + 32°C
ST from + 16°C to + 38°C
T from + 16°C to + 43°C
Advice:
After installation of your appliance, set its feet
so that it is slightly tilted backwards, it will
facilitate the closing of the door.
Before putting food, clean the interior and
exterior of your appliance with bicarbonate of
soda dissolved in water (1 tablespoon of
bicarbonate for 4 litres of water). Do not use
alcohol, abrasive powders or detergents which
could damage the surfaces. (See chapter
"Cleaning your appliance").

ELECTRICAL CONNECTION

The electrical installation must comply with the
applicable standards and must be able to
withstand the maximum power indicated on the
rating plate.
The plug must be properly grounded.
We cannot be held responsible for any incident
caused by defective electrical installation.
Electrical Installation Tips
• Do not use extension cable or adapter or
power strip.
• Never remove the grounding.
• The socket must be easily accessible but out
of reach of children.
In case of doubt, ask to your installer.
Your device is compliant with EU directives and
their modifications.

ENERGY SAVING

To reduce the power consumption of your
appliance:
• Install it in a suitable location (see "Installing
your appliance").
• Keep doors open for as short time as
possible.
• Do not put hot food in your refrigerator or
freezer, particularly if they are soups or
preparations which emit a large amount of
steam.
• Ensure the optimal functioning of your device
by not letting accumulate too much frost in the
freezer (defrost it when the ice thickness
exceeds 5-6 mm) and periodically cleaning the
condenser (see "Maintenance your device ").
• Regularly check the door seals and make sure
that they always close effectively. If this is not
the case, please contact service after sales
service.
• Do not let it set at too low a temperature.
• Not fulfilling with drawers, bins and shelves
arrangement could lead to increased energy
consumption.
6