Publicité
6
Manipulation with the control electronics
You may perform the following functions in the user menu:
set calibration of the pellet auger,
monitor temperature,
choose one of four predefined powers,
set the timer for the pellet stove switching-on and switching-off.
Fig. №. 9
6.1
User menu
TO ACTIVATE THE „SLEEPING" DISPLAY, TOUCH THE SCREEN WITH THE CONTROL BUTTONS
BASIC DISPLAY SCREEN
MENU 1 – INFORMATION
Press the button
to display basic information of operation of the pellet stove:
actual flue gases temperature in °C
adjusted temperature on the room thermostat in °C
induced air flow-rate (provided the stove is equipped with a sensor for this measurement)
exhaust fan rotation speed
number of the stove working hours
number of the kindling cycles
product code
Screen 1
Information
Exhaust T [°C]
23
Room T [°C]
22
Air Flux
0
Fan Speed [rpm]
0
Work Time [h]
138
MENU 2 – MENU CUSTOMIZATION -
– to display the screen for changing of user parameters.
Press the button
Screen 1
Menu Customization
Combustion Manag <<
Heating Management
Remote Control
Chrono
Manual Load
All manuals and user guides at all-guides.com
Screen 2
Information
Ignition [nr]
Prod. Code
Screen 2
Menu Customization
Cleaning Reset <<
93
Navigation in menu „UP", increase the value
Navigation in menu „DOWN", decrease the value
Button in menu „EXIT"
Button in menu „CONFIRM"
Button in menu „ON/OFF" or „CONFIRM"
Indication lamp „WARNING"
23
494-6000
GB
GB
Publicité
