Publicité
Quick Start
To attach the MultiSync
these instructions:
1. Turn off the power to your computer.
2. If necessary, install the display card into your system. For more information,
refer to the display card manual.
3. For the PC: Connect the 15-pin mini D-SUB of the captive signal cable to the
connector of the display card in your system (Figure A.1). Tighten all screws.
For the Mac: Connect the MultiSync A
cable adapter (not included) to the monitor connector on the Macintosh
(Figure B.1). Attach the 15-pin mini D-SUB end of the captive signal cable to
the MultiSync A
500
computer (Figure B.1). Tighten all screws.
NOTE: To obtain the MultiSync A
NEC Technologies at (800) 820-1230.
4. For download information on the Windows
MultiSync monitor, refer to the References section of this User's Manual.
5. Connect one end of the power cord to the MultiSync A Series monitor and the
other end to the power outlet (Figure C.1).
6. Turn on the monitor (Figure D.1) and the computer.
NOTE: If you have any problems, please refer to the Troubleshooting section of
this User's Manual.
78134441.wpc
All manuals and user guides at all-guides.com
A Series monitor to your system, follow
®
500
+ or MultiSync A
700
+ or A
500
Captive Signal Cable
Figure A.1
3
5
+
or MultiSync A
™
700
+ Macintosh cable adapter on the
+ Macintosh cable adapter, call
700
®
95/98 INF file for your
15-pin mini D-SUB
11/20/98, 12:33 PM
+
Macintosh
™
Publicité
