Publicité
Handset battery installation
Install the battery as shown below.
1.
Plug the battery connector
securely into the socket.
3.
Slide the battery compartment cover
towards the center of the handset until
it clicks into place.
IMPORTANT:
Check for a dial tone by pressing
successful.
If you do not hear a dial tone:
•
Make sure the installation procedures described above are properly done.
•
It may be a wiring problem. If you have changed your telephone service to digital service from a
cable company or a VoIP service provider, the telephone line may need to be rewired to allow all
existing telephone jacks to work. Contact your cable/VolP service provider for more information.
Handset battery charging
Once you have installed the battery, the screen indicates the battery status. For
best performance, keep the handset in the handset charger when not in use. The
battery is fully charged after 11 hours of continuous charging.
Battery indicators
Battery status
The screen is blank, or
The battery has no charge or
shows Put in charger and
very little charge. The handset
flashes.
cannot be used.
The screen shows
The battery has enough
charge to be used for a
Low battery
and
short time.
flashes.
The screen shows
The battery is charged.
HANDSET X.
2.
Place the battery with the label
THIS SIDE UP facing up and
the wires inside the battery
compartment.
4.
Place the handset in the telephone
base or charger to charge.
CHARGE light
remains on
when charging.
. If you hear a dial tone, the installation is
Action
Charge without interruption
(at least 30 minutes).
Charge without interruption
(at least 30 minutes).
To keep the battery charged,
place it in the handset
charger when not in use.
3
Publicité
