10-801 /10-802
step 4: ending programming status
18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35
1
1
3
1 2 3 4 5 6 7 8 9
10 11 12 13 14 15 16 17
the "mode" button
note: The parallel programming of multiple internal units (max. 2 on the power supply
module or more with the service unit) will increase the power consumption. The
numbers given in table 1 will then NO LONGER apply.
remark: If you do not have access to the premises, and thus cannot pick up the receiver of
the internal unit, you can carry out the programming via the service unit (reference:
10-870, see manual). If a bell push-button is present at the front door, you can
also carry out the programming as follows:
step 1: entering system programming status
The LED is on.
18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35
1
1
3
1 2 3 4 5 6 7 8 9
10 11 12 13 14 15 16 17
the "mode" button
step 2: linking the bell push-button to the correct internal unit
12V 1A max
12V 1A max
12V 1A max
step 3: programming a bell push-button
Briefly press the relevant bell push-button at the front door. You hear a
ringing signal both on the internal and external unit in confirmation of
the programming.
28
Briefly press
Briefly press
Press the bell push-button at the door, release it and press it
again (within 3s
1
2
6s
18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35
1
1
3
1 2 3 4 5 6 7 8 9
10 11 12 13 14 15 16 17
The LED lightens steadily.
18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35
1
1
3
1 2 3 4 5 6 7 8 9
10 11 12 13 14 15 16 17
The LED blinks.
EN