Publicité
Thank you for purchasing a TSI
Q-Trak™ XP Indoor Air Quality Monitor (IAQ). This guide
will help you quickly begin using your monitor.
More detailed information is in the Operation Manual
located on the included Q-Trak™ XP USB Flash Drive.
Please refer to the manual if you have questions on the
operation of your new monitor.
Safety
Refer to the Q-Trak™ XP Indoor Air Quality Monitor
Mode 7585 user manual for safety information.
The instrument must be used in the manner
described in the user manual. Failure to
follow all of the procedures described in the
manual can result in serious injury to you or
can cause irrevocable damage to the
instrument.
Unpacking and Parts
Identification
Carefully unpack the instrument and accessories from the
shipping container. Check the individual parts against the
list of components below. If anything is missing or
®
damaged, notify
TSI
immediately. All standard equipment
can be purchased separately if needed.
Part No.
Description
7585
Includes Q-Trak™ XP Base
Meter 7580, Multi-Sensor
IAQ Module 801430 and
Carbon Dioxide (CO
801399
Base Meter only – Handle
7580
portion
801399
CO
(Carbon Dioxide), NDIR
2
(Nondispersive Infrared
sensor)
801430
IAQ Multi-Sensor Gas
Module with Built-in Sensors:
Particulate Matter,
Temperature, Relative
Humidity and Barometric
Pressure
All manuals and user guides at all-guides.com
®
Incorporated (TSI
®
)
W A R N I N G
Picture
) sensor
2
Part No.
Description
800121
Carrying Case
800123
Lithium Ion Rechargeable
Battery Pack
804001
USB Cable
800122
AC Adapter/Power Supply
6013908
Q-Trak™ XP IAQ Monitor
Quick Start Guide
800120
Gas Sensor Calibration Cap
7004035
USB Flash Drive with
Q-Trak™ XP manuals and
other literature.
Installation of Gas Sensors
In addition to the standard built-in sensors, the device can
accept up to six gas sensors.
Install the gas sensors as follows:
1. Ensure the instrument is powered OFF.
2. Remove the sensor module cover.
-2-
Picture
Publicité
